Aggregator Firmware Fails: Code 10

Discussion in 'Microsoft Surface Pro 3' started by p-coop, Nov 10, 2015.

  1. p-coop

    p-coop New Member

    Joined:
    Nov 10, 2015
    Messages:
    1
    Likes Received:
    0
    Trophy Points:
    1
    My Device:
    SPro3
    Kind greetings.

    The Surface Pro System Aggregator Firmware will not apply correctly. I see the firmware installing on boot, but when I go into Device Manager, I see an error message "This device cannot start (Code 10). {Operation Failed} The requested operation was unsuccessful."

    I have tried the following to no avail:
    Powered off the Surface Pro
    Held Volume Up and Power Button for 10 seconds
    Released Buttons
    Waited 5-10 seconds
    Powered on the Surface

    Any time the Surface reboots, it tries to install the firmware.

    Any thoughts on how I can successfully get the firmware installed?

    Thanks.
     

Share This Page

Search tags for this page
aggregator firmware
,
pro 4 surface system aggregator firmware failed to install
,
surface 4 firmware code 10
,
surface book firmware code 10
,

surface embedded controller firmware code 10

,
surface embedded controller firmware code 10 4
,
surface pro system aggregator firmware cannot start
,
surface pro system aggregator firmware code 10
,
surface system aggregator failed to install
,
surface system aggregator firmware error