Pro Dock 3 Dimensioning

Discussion in 'Microsoft Surface Accessories' started by KilledByVen, Aug 19, 2014.

  1. KilledByVen

    KilledByVen New Member

    Joined:
    Aug 19, 2014
    Messages:
    5
    Likes Received:
    0
    Trophy Points:
    1
    [​IMG]
    Does anyone have one of these yet and is willing to help me? I am after the thickness of the base plate in millimeters, and also the angle between the base and the top, as I wish to mount this to my desk, to hide all the wiring, and as i have already begun construction of the desk, I would like to cut the hole out for it prior to painting it, as they arent available in Australia till late september I cannot physically go to a store to check. Many thanks!
    [​IMG]
     
  2. Len J

    Len J Active Member

    Joined:
    Aug 2, 2014
    Messages:
    134
    Likes Received:
    31
    Trophy Points:
    28
  3. KilledByVen

    KilledByVen New Member

    Joined:
    Aug 19, 2014
    Messages:
    5
    Likes Received:
    0
    Trophy Points:
    1
    Hi, I already have those dimensions, as per picture 1 posted. I think i could work out the angle if i just had the thickness of the two parts if anyone could provide that.
     
  4. malberttoo

    malberttoo Super Moderator Staff Member

    Joined:
    Feb 26, 2013
    Messages:
    2,255
    Likes Received:
    428
    Trophy Points:
    83
    Location:
    Alaska
    My Device:
    SPro3

    Hi Kelly, welcome to the forum!

    I would love to see pics of that desk when you're done! :D
     
  5. KilledByVen

    KilledByVen New Member

    Joined:
    Aug 19, 2014
    Messages:
    5
    Likes Received:
    0
    Trophy Points:
    1
  6. Len J

    Len J Active Member

    Joined:
    Aug 2, 2014
    Messages:
    134
    Likes Received:
    31
    Trophy Points:
    28
    My IPhone app says it's 26 degrees off of upright. or 64 degrees from a flat surface. not a calibrated measure BYW

    Len
     
    KilledByVen likes this.
  7. KilledByVen

    KilledByVen New Member

    Joined:
    Aug 19, 2014
    Messages:
    5
    Likes Received:
    0
    Trophy Points:
    1
    ah ok, well even with that rough measurement, thats perfectly fine then! I have the top rise slanted at 30 degrees, so if I just make the hole the thickness of the backpart, I wont have to calculate for any slight tilt! Thanks a bunch.

    Any chance on how thick the back part is though? TY
     

Share This Page