Fiddling with the magnetic power charger cord

The key is to hold the cord by the cord about an inch above the plug so that it is kind of floppy in your hand. Then put the top edge in first and the magnet takes over and snaps the rest right in. If you hold it too tightly the magnet cant do its thing.

Using this method is instant connection every time.
 
The key is to hold the cord by the cord about an inch above the plug so that it is kind of floppy in your hand. Then put the top edge in first and the magnet takes over and snaps the rest right in. If you hold it too tightly the magnet cant do its thing.

Using this method is instant connection every time.

This! That's what I do and I've had no issue
 
I think all they really need to do is round the edges of the tip and make the tip a little wider and it will slip right in. The sharp edges tend to catch too much instead of slipping in and the slot is a little too narrow.

Rounded:

View attachment 376

Sharp:

View attachment 378

This is the problem, I shaved down the hard corners and havn't had a problem with it seating improperly since.
 
My charger port is still pristine (absolutely no scratches). I can attach my cord in about 2 seconds.... sometimes faster! :p
 
if the chord itself was attached to the middle length of the connector as opposed to the end edge I think this issue would disappear. Hey Microsoft, its time for a revised charger...
 
The key is to hold the cord by the cord about an inch above the plug so that it is kind of floppy in your hand. Then put the top edge in first and the magnet takes over and snaps the rest right in. If you hold it too tightly the magnet cant do its thing.

Using this method is instant connection every time.

this method works amazingly! thanks!
 
I hold it about 3 inches back and just ease it into the vicinity and the magnets grab it just fine.
Been thinking of making a video for this ... hard to believe so many people have so much trouble with it.
 
My sub-conscious brain now tells me how to connect it. :p
 
Back
Top